Eliminates speaker insertion loss.Conference room speaker system

　　The so-called insertion loss refers to the part of the power that is output by the power amplifier, but cannot be transmitted to the speaker and converted into sound. The built-in frequency division is also called LC frequency division. Its principle is to use the low-pass and high-pass characteristics of the inductor (L) and the capacitor (C) to prevent a part of the frequency signal from passing through a certain circuit, thereby completing the frequency division. However, the components such as inductors and cement resistors used in the built-in frequency divider are power components that consume a lot of energy. The energy lost on these components constitutes the so-called "insertion loss", and the more the frequency divider is complex, the greater the insertion loss will be.

　　After using bi-amp or tri-amp drive, since there is no third device between the output of the power amplifier and the speaker unit, it can perfectly eliminate the insertion loss, that is, its utilization rate for the output energy of the power amplifier is significantly higher.

　　better phase characteristics

　　In addition to the trouble caused by the internal resistance of the LC components of the power divider, the phase effects brought by them as the phase components also need to be carefully considered when designing the power frequency divider. For a speaker, at different frequencies, the phase situation of the tweeter and the frequency divider is very complicated. If the phase problem is not considered when designing the frequency divider and appropriate phase compensation is made, it is likely to cause Although the frequency division attenuation of the tweeter and woofer is perfect, due to the inconsistent phase of the two, the curve is uneven, and even a speaker with a perfect curve but poor phase, the sound is often better than no phase problem, but the curve is not too good The ideal speaker is much harder to hear.

　　After using bi-amp or tri-amp drive, the circuit design of electronic frequency division is easier than the built-in frequency division in phase control, and the phase characteristic is much better than the built-in frequency division.

　　More precise drive power distribution

　　After using bi-amp or tri-amp drive, each speaker unit can obtain accurate driving power, give full play to their respective advantages and characteristics, and the sound quality is more pure and pleasant.

　　Crossover point and crossover characteristics are easier to control

　　Speakers driven by bi-amp or tri-amp use integrated circuit active filter for frequency division. Before the amplifier, the sound signal is very weak, so it is easy to completely divide the sound, which can be easily adjusted by adjusting the input parameters. The crossover characteristics make up for the acoustic defects of the unit in a certain frequency band, and at the same time reduce the crossover area of the crossover, with good adjustability and improved electro-acoustic indicators.

Read recommendations:

I3 Small bar sound Vendor

MB210 Low Profile Bar audio set Merchant

A3 Home ktv audio Merchant

What are the steps to debug the KTV bar sound?

Shanghai MASTER bar dedicated sound system is provided by Ma Teng Audio