Preparation before system debugging of professional audio manufacturer!Hunan Bar Audio Vendor

　　We have mentioned the process of system debugging for professional audio manufacturers, but you must not forget the preparations before debugging. The debugging of sound engineering is an operation that requires skills and experience as well as careful and detailed spirit. When the planning and construction meet the requirements, the commissioning is unreasonable and not detailed, which not only fails to achieve the planning effect of the project, but may also cause the equipment to operate in an abnormal state. So we must fully realize the importance of this task before debugging

　　Before debugging, professional audio manufacturers must carefully acknowledge whether each piece of equipment is installed and connected correctly, and carefully ask the construction personnel about issues that may affect the use of the construction; before debugging, they must carefully acknowledge whether each piece of equipment is installed and connected correctly and carefully. Ask the construction staff about the problems left by the construction that may affect the application; before debugging, you must carefully read all the equipment manuals again, and carefully consult the markings and connection methods of the planning drawings; before debugging, you must make sure that there are no problems with the power supply line and the power supply voltage. ; Before debugging, make sure that there are no off-site personnel; prepare corresponding instruments and tools before debugging.

https://www.nxbtx.com/rf_isolators/

　　Debugging by professional audio manufacturers is the key to engineering debugging. The audio system touches the most equipment, debugs the most parts, and may encounter the most problems, so we must first concentrate on completing it. Required instruments and tools: phase meter, noise generator, spectrum analyzer (including sound level meter), multimeter, etc.

Read recommendations:

PSM18 POINT SOURCE MONITOR Speaker bar Factory

PSM 12 POINT SOURCE MONITOR Speaker bar company

F215 MK2 ktv bar sound Factory

How to make bar audio equipment show better sound quality?Bar sound engineering Vendor

"20-200W" marked on the KTV audio equipment nameplate