Home audio installation and debugging

　　When consumers choose to be suitable for their speakers, the next job is to make a series of work such as swinging, installation, and debugging the speakers. Because the home theater system has a strict standard in terms of installation, positioning, and debugging of speakers, which means that users can only get the ideal sound to install and debug the speakers if they comply with these specifications. Xiaobian has also mentioned some related installation steps and debugging methods for home theater speakers, but it may only explain only a special environment, and it may not be suitable for other family environments. Therefore, we will introduce the installation and commissioning of the speakers for the general family environment, and we hope to give consumers a guidance.

　　Installation of the speaker in front

　　There are two main speakers and a medium set of speakers in front of the soundtrack. For short LCR channels, these three speakers need to be responsible for most of the sounds in the sound field. Therefore In order to obtain a good sound field and the correct positioning of life. For some consumers, you can try to install the middle setting speaker on the upper or lower edge of the display device, and then adjust the radiation direction of the sound phase. However, this method must pay attention to The angle between the installation height and the two channel speakers cannot be greater than 10 degrees, so as not to destroy the acoustic acoustic positioning and sound field.

　　Installation of surround speakers

　　The surround speakers sold on the market have occasional radiation speakers and traditional direct radiation speakers, facing the current 7.1 provincial AV system. You need to use 4 surround speakers. Generally, you can configure 4 puppet radiation speakers, or the side sounds are used to use the puppet pole speakers, and the rear provincial highway uses a direct radiation speaker. These speakers also have some specific requirements. For example: Direct radiation speakers directly point the radiation direction to the listening position like the LCR channel in front, and for the "zero zone" of the speaker to the listening position for the coupling polar speakers. In terms of the installation height of the speaker, according to THX's example, the height is about 1.8m ~ 2.2m, then consumers need to use the speaker bracket to fix the speaker on the wall. Some speaker manufacturers now launch the corresponding speaker brackets according to their products when producing speakers to facilitate consumers to buy and use.

Read recommendations:

D2 AMPS Bar speakers wholesaler

Resolution 5E Big sound bar Vendor

C10 Sound bar manufacturer

Tell you the rules and requirements for the combination of audio equipment and equipment!

Shanghai's popular bar MASTER CLUB bar sound provided by MASTER CLUB