KTV audio equipment terminology

　　To understand this KTV audio equipment technical common sense, the first term common sense to understand is this. It refers to the electrical power that the power amplifier or speaker can accept for more than 8 hours of normal operation without damage without distortion.

　　We all know more about this term in common sense, and we will not introduce more important common sense to us here.

　　Peak power

　　Peak power literally means what do you think it refers to? In fact, it refers to the largest strong pulse that professional audio equipment can accept within 1/100 second, that is, within 10 milliseconds, and the equipment is not affected. Burn out, this power is generally 8-10 times the rated power.

　　Music power

　　The audio equipment imitates the operating power when the music is being played.

　　We should have a brief understanding of the above three points. Have we learned some common sense through our detailed introduction today? Next, let’s take a look at the two related terms of "matching" in the common sense of professional audio equipment terminology:

　　Let's first look at power matching. For KTV facility management personnel, they should have a good understanding of this terminology. KTV audio equipment must pay attention to this. From the literal meaning of the term common sense, we can understand what it means. The second is impedance matching. When KTV audio equipment is used, the output impedance of the power amplifier is required to be consistent with the input impedance of the speaker.

　　Crossover point

　　Although we don't know the crossover point very well, we should be very familiar with the crossover! The crossover point refers to the dividing point between the high-pass, band-pass and low-pass filters of the crossover. This acoustic term is often expressed by frequency, and its unit is hertz. When talking about this common sense of audio terminology, I will share some common sense with us briefly: in the high and low frequency two-way speakers we use, it has only one crossover point, while the high, medium, and low three-way speakers have Two crossover points. We also need to pay attention to the common sense that the audio crossover point should be specifically confirmed according to the frequency characteristics and power distribution of the speaker unit or audio of each frequency band.

　　Peak appearance

　　In this term, the peak appearance can again become the clipping appearance. When the input signal of the audio equipment we use is too strong, severe distortion will occur, which will damage the sound quality, and may even cause the equipment to burn. In order to show the excessively strong state in time, all mixers and most audio equipment are equipped with peak display. When it is flashing and the TF may always be in the bright state, it means that the input signal is too strong and it must be high-speed Signal gain.

　　Peak music power

　　This professional audio term refers to the ability of audio equipment to receive instantaneous strong signals. Generally, this value can be marked very high, generally 8 to 10 times the rated power of the meter.

Read recommendations:

Resolution 1.5TT Marten Audio company

Resolution 4S Skeletal Bar use audio Vendor

DS15 Bar speakers Merchant

Chongqing CLUB DNA audio system is provided by Mateng Audio.Bar hall sound

How to distinguish between monitor speakers and ordinary speakers.Shenzhen conference room audio